Filter
Top Products
14
Remove Sawdust From
Guide Bar Groove
Oil Holes
S Burring of guide bar rails is a normal
process of rail w ear. Remove these burrs
with a flat file.
S When rail top is uneven, use a flat file to
restore square edges and sides.
Correct GrooveWorn Groove
File Rail Edges
and Sides
Square
Replace guide bar when the groove is worn,
the guide bar is bent or cracked, or when
excessheatingorburringoftherails occurs.If
replacement i s necessary,useonly the g uide
bar specified for your pruner in the repair
parts list.
LUBRICATION
Bar Oil
Fill Cap
S See GUIDE BAR AND CHAIN OIL under
the OPERATION section.
REPLACE SPARK PLUG
Replace the s park plug eac h year to ensure
the engine s tarts easier and r uns better. Set
spark pluggap at0.025 inch.Ignition timingis
fixed and nonadjustable.
1. Twist, then pull off spark plug boot.
2. Remove spark plug from cylinder and
discard.
3. Replace with Champion RCJ-6Y spark
plug and tighten securely with a 3/4 inch
socket wrench.
4. Reinstall the spark plug boot.
SERVICE AND ADJUSTMENTS
WARNING: Disconnect the spark
plug before performing maintenance, service,or
adjustments except for carburetor adjustments.
CHAIN SHARPENING
Chain sharpening is a c omplicated task that
requires specialtools.We recommendedyou
refer chainsharpeningtoaprofessionalchain
sharpener.
CHAIN REPLACEMENT
WARNING: Wear protective gloves
when handling chain. The chain is sharp and
can cut you even when it is not moving.
It is normal for a new chain to stretch during the
first 15 minutes of operation. Y ou should re-
check your chain tension f requently and adjust
thechain tensionas required.See CHAIN TEN-
SION s ection.
Replace the old chain when it becomes worn or
damaged. Use only the Low-Kickback replace-
ment chain s pecified in t he repair parts list.
TO REPLACE CHAIN:
1. MoveON/OFFswitchtotheOFFposition
and disconnect spark plug.
2. Remove bar clamp nut.
3. Remove bar clamp.
4. Turn adjusting screw by hand counter-
clockwise until adjusting pin just touches
the stop.
5. Slide guide bar behind sprocket until
guide bar stops against sprocket.
6. Remove the old chain.
7. Carefully remove new chain from pack-
age. Hold chain with the drive links as
shown.
CUTTERS MUST FACE IN
DIRECTION OF ROTATION
Tip of
Bar
Cutter
Drivelink
Cutters
Depth Gauge
Drive Links
8. Place chain over sprocket, fitting the
drive links in the sprocket.
9. Fitbottomofdrivelinksbetweentheteeth
in the sprocket in the nose of the guide
bar.
10. Fit chain drive links into bar groove.