Filter
Top Products
5
Spacer Tabs
LOWER SHOULDER STRAP
CLAMP
Spacer Tabs
positioned for use
on 1
"
diameter
upper tube
1. Place the upper shoulder strap clamp
over the upper tube above thehandlebar.
2. Position the lower shoulder strap clamp
under the upper tube and align the upper
and lower clamp screw holes (use
spacer tabs between upper and lower
clamps if necessary to secure clamp, i.e.
for 1
"
diameter upper tube).
Upper Shoulder
Strap Clamp
Screws
Lower Shoulder
Strap Clamp
POWERHEAD
END
A TTACHMENT
END
3. Insert two screws into the screw holes.
4. Secure shoulder strap clamp by tighten-
ing screws with the hex wrench.
5. Try on shoulder strap and adjust for fit and
balancebeforestartingtheengine orbegin-
ning a cutting operation.
6. Insert your right arm and head through
the shoulder strap and allow it to rest o n
your left shoulder. Make sure the danger
sign ison yourback and thehook istothe
right side of your waist.
NOTE:
Aone-half twist isbuilt intheshoulder
strap toallow thestrap torest flat ontheshoul-
der.
7. Adjust the strap, allowing the hook to be
about 6 inches below the waist.
8. Fasten the strap hook to the upper clamp
and lift the tool to the operating position.
Shoulder Strap
Shoulder
Strap
Clamp
OPERATION
KNOW YOUR BRUSHCUTTER ATTACHMENT
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
BRUSHCUTTER ATTACHMENT. Compare the illustrations with yourunit t o familiarize yourself
with the location of various controls and adjustments. Save this manual for future reference.
B
l
a
d
e
S
h
i
e
l
d
Locking Lever
Blade
Gearbox
Tube
Hanger
BLADE
The BLADE i s designed for cutting grass,
weeds, and brush up to 1/2 inch in diameter.
LOCKING LEVER
The LOCKING LEVER is used to prevent the
blade shaft from turning during blade replace-
ment.