Filter
Top Products
17
TO START ENGINE
CAUTION: The mow er blade rotates
whenever the engine is running.
• Move engine speed control to FAST
position or to CHOKE/START position
on models equipped with choke fea ture.
• If your mower has a primer, to start a
cold engine, push primer the num ber of
times as instructed in the engine manual
packed with your mower. Use a fi rm
push. This step is not usually nec es sary
when start ing an engine which has
already run for a few minutes.
• Hold operator presence control bar
down against han dle.
• Pull starter handle quickly. Do not allow
starter rope to snap back.
• For engines equipped with choke, slowly
move engine speed control lever to
FAST position after engine starts.
• To STOP engine, release operator pres-
ence engine control bar.
NOTE: For engines with a primer, it may be
nec es sary to repeat priming steps in cooler
weather. In warmer weath er, overpriming
may cause fl ood ing and en gine will not start.
If you do fl ood engine, wait a few minutes
before attempting to start and DO NOT
repeat priming steps.
MOWING TIPS
CAUTION: Do not use de-thatcher
blade attachments on your mower. Such
attachments are hazardous, will damage
your mower and could void your warranty.
• For most cutting conditions and bet ter
bagging per form ance, the engine speed
should be set in the FAST po si tion.
• Under certain conditions, such as when
mowing very tall grass, raise the mower
height on the fi rst cut to reduce pushing
effort, to avoid over heat ing the engine, and
to avoid leaving clumps of grass clippings.
Make the second cut to the desired height.
• For extremely heavy cutting, reduce the
width of cut.
• For side discharge lawn mowers, cut in a
coun ter clock wise di rec tion, start ing at the
outside of the area to be cut, in order to
spread grass clip pings more evenly and
to put less load on the engine. To keep
clip pings off of walkways, fl ower beds, etc.,
make the fi rst cuts in a clock wise direction.
Recoil
starter
handle
Operator
presence
control bar
• When using a rear discharge lawn
mower in moist, heavy grass, clumps
of cut grass may not enter the grass
catcher. Reduce ground speed (push ing
speed) and/or run the lawn mower over
the area a second time.
• If a trail of grass clipping is left on the right
side of a rear discharge lawn mower, mow
in a clockwise direction with a small overlap
to collect the clippings on the next pass.
• Pores in cloth grass catchers can be-
come fi lled with dirt and dust with use
and the catcher will collect less grass.
To prevent this, regularly hose catcher
off with water and let dry before use.