Filter
Top Products
11
INSTALL DISCHARGE
GUARD
(SIDE DIS CHARGE MODELS ONLY)
(USE HARDWARE GROUP “D”)
If your mower is a rear discharge mower,
go on to “INSTALL CON TROL BAR”.
MODELS WITH BOLT-ON GUARD:
NOTE: If your discharge guard has ribbing
as shown in the illustration below, there
are two (2) spacers which must be placed
between guard and mower housing.
• Place discharge guard on top of lawn
mower discharge opening.
• Install two (2) 1/4-20 short hex bolts
through housing and discharge guard.
• Install two (2) 3/4" washers and two
(2)1/4-20 locknuts. Tighten securely.
BOLT-ON GUARD WITHOUT RIBBING:
BOLT-ON GUARD WITH RIBBING:
Hex bolts
Washers
Discharge
guard
Locknuts
Hex bolts
Washers
Spacers
Discharge
guard
ribbing
Locknuts
Locknuts
Discharge
guard
MODELS WITH SPRING LOADED
DISCHARGE GUARD:
• Place discharge guard on top of lawn
mower discharge opening.
• Install two (2) hex self-tapping screws
through housing and into guard mount-
ing bracket or, install two (2) 1/4-20
locknuts (If equipped). Tight en securely.
INSTALL CONTROL BAR
(NO HARDWARE REQUIRED)
• Position control bar so fl attened sec tion
with hole is on opposite side of upstop
bracket.
• Insert one end of control bar into hole be-
hind upstop bracket. Carefully push in on
opposite end of control bar and insert into
formed hole on inside of upper handle.
Up-stop bracket
Control bar