Filter
Top Products
13
Mowing
SWEEPING -- Thefanningactionof therotat-
ing line can be use d for a quick and easy
clean up. Keep the line parallel to and above
the surfaces being swept and move the tool
from side to side.
Sweeping
MAINTENANCE
WARNING: Disconnect the spark
plug before performing maintenance except
for carburetor adjustments.
HELPFUL TIP
IMPORTANT: Have all
repairs other than the rec-
ommended maintenance
described in the instruction
manual performed b y an
authorized service dealer.
If any dealer other than an authorized
service dealer performs work on the
product, Poulan PRO may not pay for
repairs under warranty. It is your re-
sponsibility to ma intain and perform
general maintenance.
CHECK FOR LOOSE
FASTENERS AND PARTS
S Spark Plug Boot
S Air Filter
S Housing Screws
S Assist Handle Scr ew
S Debris Shield
CHECK FOR DAMAGED OR
WORN PARTS
Contact a n authorized ser vice dealer for re-
placement o f damaged or worn par ts.
S ON/STOP Switch -- Ensure ON /ST OP
swit ch functions properly by pushing and
releasing the swi tch. Make sure engine
stops. Wait 5 seconds before attemptingto
restart unit to allow switch to reset. R estart
engine and continue.
S Fuel Tank -- Discontinue use of unit if fuel
tank shows signs of damage or leaks.
S Debris Shield -- Discontinue use of unit if
debris shield is damaged.
INSPECT AND CLEAN UNIT AND
LABELS
S After each use , inspect complete unit for
loose o rdamaged parts. Clean t h eunit a nd
labels using a damp cloth with a m ild deter-
gent.
S Wipe off unit with a clean dry cloth.
CLEAN AIR F ILTER
A dirty air filter decreases engine per form-
ance and increases fuel consumption and
harmful emissions. Always clean after eve ry
5 hours of operation.
1. Clean the cover and the area around it to
keep dirt from falling into the carburetor
chamber when the cover is removed.
2. Remove part s by pressing button to re-
lease air filter cover .
NOTE: To avoid creating a fire hazar d or
producingharmful evaporative emissions,do
not clean filter in gasoline or other flammable
solvent.
3. Wash the filter in soap and water.
4. Allow filter to dry.
5. Replace parts.
Button
Air Filter Cove r
Air Filter
MUFFLER AND SPARK ARREST-
ING SCREEN
WARNING: The muf fler on this prod-
uct contains chemica ls known to th e State of
Califo rnia to cause cancer.
As yourunit is used, carbon deposits buildup
on the muffler and spark arresting screen.
For normal homeowner use, however, the
muffler andspark arresting screen will not r e-
quire any service. A fter 5 0 hours of use, we
recommend t hat your muffler be serviced or
replaced by your authorized service dealer.
REPLACE SPARK PLUG
Replace the spark plug each year to ensure
the engine starts easier and runs better. Set
spark plug gap at 0.025 inch (0.6 mm). Igni-
tion timing is fixed and nonadjustable.
NOTE: This spark ignition system complies
with the Canadian standard ICES--00 2.
1. Twist, then pull off spar k plug boot.
2. Remove spark plug from cylinder and
discard.
3. Replace with Champion RCJ-6Y spark
plug and tighten securely with a 3/4 inch
(19 mm) socket wrench.
4. Reinst all the spark plug boot.