Poulan 115153026 Chainsaw User Manual


 
19
TROUBLE CAUSE REMEDY
Engine will not
start or w ill run
only a few
seconds after
starting.
1. Ignition switch of f.
2. Engine flooded.
3. Fuel tank em pty.
4. Spark plug not firing.
5. Fuel not reaching
carburetor.
1. Move ignition switch to ON.
2. See “Difficult Starting” in
Operation Section.
3. Fill tank wi th correct fuel mixture.
4. Install new spark plug.
5. Check for dirty fuel filter; replace.
Check for kinked or split fuel line;
repair or replace.
Engine will
not idle
properly.
1. Idle speed r equires
adjustment.
2. Carburetor requires
adjustment.
1. See “Carburetor Adjustment” in the
Service and Adjustments Section.
2. Contact an authorized service dealer.
1. Air filter dirty.
2. Spark plug fouled.
3. Chain brake engaged.
4. Carburetor requires
adjustment.
Engine will not
accelerate,
lacks power,
or dies under
a load.
1. Clean or replace a ir filter.
2. Clean or replace p lug and regap.
3. Disengage c hain brake.
4. Contact an authorized service dealer.
Engine
smokes
excessively.
1. Too m uch oil mixed with
gasoline.
1. Empty fuel tank and refill with
correct fuel mixture.
WARNING: Always stop unit and disconnect spark plug before perf orming all of
the recommendedremedies below except remedies that require operationof the unit.
TROUBLESHOOTING TABLE
Chain m oves
at idle speed.
1. Idle speed requires
adjustment.
2. Clutch r e quires repair.
1. See “Carburetor Adjustment” in the
Service and Adjustments Section.
2. Contact an authorized service dealer.