Filter
Top Products
8- ENG
A17914
Risk of personal
injury. Avoid
placing hands between handle and
frame when assembling to prevent
pinching.
4. Connect wand to gun. Tighten
securely.
5. Attach high pressure hose to gun.
Tighten se cure ly.
NOTE: The pump on this unit is
maintenance free and requires no oil,
if there is a problem with the pump
contact an Authorized Service Center.
Risk of bursting.
Use a tire pressure
gauge to check the tires pressure
before each use and while inflating
tires; see the tire sidewall for the
correct tire pressure.
NOTE: Air tanks, compressors and similar
equipment used to inflate tires can fill
small tires similar to these very rapidly.
Adjust pressure regulator on air supply
to no more than the rating of the tire
pressure. Add air in small increments
and frequently use the tire gauge to
prevent over inflation.
ASSEMBLY INSTRUCTIONS
1. To Assemble Quick Connect
Grommets:
a. Squeeze grommet and place
into hole, fitting groove to
rim.
b. Push grommet into place.
c. Repeat steps until all
grommets are assembled.
2. To Assemble Quick Connect
Nozzles:
a. Remove four
colored
quick
connect
nozzles from
plastic bag
and insert
them into
correct
grommet. NOTE: Nozzles
are color coded to match
colored nozzles on panel.
3. Place handle assembly onto
frame, depress the snap buttons,
and slide the handle assembly onto
the frame until snap buttons snap
into place.