Filter
Top Products
15 - ENG
A17914
HOW TO CLEAN THE WATER
INLET FILTER
This screen filter should be checked
periodically and cleaned if necessary.
1. Remove filter
by grasping
end and
removing it
from water
inlet of pump
as shown.
2. Clean filter
by flushing it with water on both
sides.
3. Re-insert filter into water inlet of
pump.
WAND
If the nozzle becomes clogged
with foreign materials, such as dirt,
excessive pressure may develop.
If the nozzle becomes partially
clogged or restricted, the pump
pressure will pulsate. Clean the
nozzle immediately using the nozzle
kit supplied and the following
instructions:
1. Place the ON/OFF switch in the
OFF position and turn off the
water supply.
2. Unplug unit from power source
3. Pull trigger on gun handle to
relieve any water pressure.
4. Disconnect the wand from the
gun.
5. Remove the high-pressure
nozzle from the wand. Remove
any obstructions with the nozzle
cleaning tool provided and
backflush with clean water.
6. Direct water supply into nozzle
end to backflush loosened
particles for 30 seconds.
7. Reassemble the nozzle to the
wand.
8. Reconnect wand to gun and turn
on water supply.
9. Plug unit into appropriate
outlet.
10. Start pressure washer and place
wand into high pressure setting to
test.
Filter Screen