Filter
Top Products
39
6. DISTANCE MEASUREMENT
6.1 Target setting
The target mode and its Constant of current setting are shown at the left of the battery
mark. For example in case of each Constant 0, Reflector sheet; S 0,Reflectorless (Non-Prism);
N 0, Prism; P 0
Pressing [F2][TARGET] changes the target mode.
• The target mode is changed sequentially as follows.
Reflector sheet - Prism - Reflectorless (reflectorless models), Reflector sheet - Prism
(standard models).
• The selected target mode is stored in the memory even if the power is turned off.
So, next time you can use the same mode after turning on.
• The target Constant differs according to the selected target mode. So, confirm the
target mode and its Constant shown at the top screen after changing the target.
[Distance measurement by reflectorless (Non-Prism) mode]
• The measurement range and accuracy of Reflectorless are based on the condition that
laser beam is emitted perpendicular to the white side of the Kodak Gray Card.
The measurement range may be influenced by the shape of the target and its
environment.There is a possibility that the range may vary when the target does not
satisfy the conditions above at survey work.
• Pay attention to the following in case of distance measurement by Reflectorless.
In case of resulting in low accuracy, perform the distance measurement by Reflector
sheet or Prism.
• The Reflectorless “Long Range mode”can be accessed by the 007 CODE number 521
[REF.LESS RANGE]. The measurement range of this mode is 200m and the Laser closs
is IIIa.This mode can be performed by selecting the “LONG” at 1.REF.LESS RANGE.
• The CODE number 521 [REF.LESS RANGE] shows 1. REF.LESS RANGE (NORMAL/LONG),
2. LONG RANGE MES(ON/OFF) and 3. LONG RANGE SETUP(EACH TIME/PERMANENT).
• The WARNING (Laser Power) screen is displayed when Range LONG and Message ON
are selected,and then F1-MEAS key is pressed. F1-MEAS,F3- NORMAL and F5-LONG are
viewed.
• Pressing [MEAS] one time selects “Second MEAS setting”and twice selects “QUIT”.
And then, Normal or Long measurement is selected by pressing F3 or F5.
H.angle
H.dst.
V.dst.
MEAS TARGET 0 SET DISP MODE
MODE A 15°C S 0
-267° 29’ 40”
TARGET CHANGED
(CONST.:0mm)
SHEET