Filter
Top Products
16
Great White Installation and User’s Guide
Disassembly
1. Remove swivel assembly (Figure 22) from the
top of the cleaner by turning it 1/4-turn
counterclockwise and pulling straight up on it.
2. Turn cleaner upside down. Remove 4 screws and
remove lower body assembly from shroud.
3 . Turn lower body assembly right side up. Unsnap
the 2 clips on the oscillator chamber cap (Figure
23a); lift it off.
4. Pull the long gear shaft straight up (Figure 23a)
by the blocks on the ends of the shaft. Hold the
seals in the oscillator and the blocks on the shaft.
The cam may interfere with the shaft mounting
post; if so, turn it slightly on the shaft until it
clears the post. The shaft assembly can now be
disassembled (Figure 23b).
5. Slide the long gear shaft out of the oscillator
(with gears, complete); make sure that you don’t
lose the seals out of the oscillator which may fall
out at this point (Figure 23b).
5A. Oscillator seals are replaceable.
5B. Ratchet gear set and long shaft are replaceable
as a unit.
6. Remove the set screw, short gear shaft, and
gears (Figure 24); be sure to keep the gears on.
7. With a small screwdriver (such as a jeweler’s
screwdriver), a pencil, or a pen point, depress
and remove the coil spring from the lift brush
mounting post (Figure 25). Replace the brush and
the spring if necessary.
8. The metal ratchet tab slides out of its slot
sideways; replace it by removing the center
brushes and sliding in a new ratchet tab until it is
flush with the edge of plastic holder (Figures 26
and 27). Replace the center brushes.
9. The brush ring pops out of the cleaner body for
easy replacement.
10. If you need to replace the bumper, turn the
shroud and bumper assembly upside down and
remove the two screws holding the bumper to the
shroud.
Locked Twist CCW
1/4 Turn
Pull Straight
Up
"Click" at
this point
Swivel
assembly
3337 1098
1889 0795
Clip
Ocillator
Chamber
Cap
Block
Long Gear Shaft
Block
Cam
1887 0795
1. Slide metal ratchet tab
toward end of cleaner body
1885 0795
2. Slide metal ratchet tab
down through cleaner body
1884 0795
Figure 23a
Figure 22
Figure 23b
Figure 24
Figure 25
Figure 26
Figure 27
1886 0795