Filter
Top Products
7
Great White Installation and User’s Guide
Standard Installation (Continued)
5. Check Flow
With the main drain closed, and one end of the hose attached to the regulator installed in the skimmer, insert
the flow gauge into the other end of the hose. Keep the hose and flow gauge underwater. Turn on the
pump. With the pump running, adjust the vacuum regulator (in your skimmer) until the indicator on the flow
gauge is between minimum and maximum flow (Figure 12). Remove the flow gauge and proceed to step 6.
6. Connect Hose to the Cleaner’s Swivel Assembly
Connect the large hose cuff (Figure 13) of the leader hose to the swivel assembly on the cleaner head
(Figure 13). Push the cleaner into the pool and let it sink to the bottom (Figure 14).
Figure 14
Disc Indicator
Figure 12
Figure 13
Large hose cuff
of leader hose
designed to connect
to swivel assembly
(See “Hose Assembly”
on Page 3)
7. Turn the pool pump on
After completing the installation, turn the pool pump on and allow it to run for a couple of minutes to ensure
that all air cycles out of the system.