Filter
Top Products
11
USING PRE-PROGRAMS AND QUICK MASSAGE
1
2
5
4
1. Press the OFF/ON button.
2. Select the pre-program you want.
• Please press one of the flashing buttons.
• For a general explanation of pre-program characteristics, please
refer to the bottom of this page.
• For an outline of each pre-program, please refer to the information
on page 18.
• If you press another Pre-Program button during your selected pre-
program massage, the massage will switch to the newly selected
pre-program.
The Selected Program will Start
• It is possible to change the pre-program selected or to change to
manual operation mid-way through a massage.
• In pre-programs, the leg massage begins at the same time.
It is possible to stop or change the intensity of the leg massage
during the program. (See Page 17)
3. Sit as far back in the seat as possible with your
head on the pillow.
About the Time Indicator
Head rests
on pillow.
Approx. 15 min.
Approx. 9 min.
Approx. 3 min.
Time Remaining
Press
• The OFF/ON indicator will come on.
•
You can now select one of the pre-programs or one of
the manual settings.
• Pressing a Pre-Program button
automatically moves the backrest and
legrest into massage position.
• If the massage lounger is reclined
further than this angle then it will not
automatically recline.
• Do not place leg between armrest and
legrest.
Doing so may result in pinching of leg
when legrest rises.
• Displays remaining massage time via flashing
LED.
• Starts counting down from 15 minutes in
increments of approximately 3 minutes.
• Flashing speeds up one minute before end of
massage.