North Star M165938N Portable Generator User Manual


 
Operation (cont’d)
28
Always dissipate static charge from your body before beginning
the fueling process by touching a grounded metal object at a safe
distance from fuel sources.
Never fill the generator’s gas tank directly from the fuel pump –
the generator’s tank is not grounded and high velocity flow from
the pump can cause static electricity build-up. Use an approved
portable container to transfer gas to the generator’s tank.
Never fill the portable gas container while it is sitting inside a
vehicle, trailer, trunk, or pick-up truck bed. ALWAYS place
container on the ground to be filled.
Keep nozzle in contact with portable container while filling.
Manually control the flow of gasoline; do NOT use nozzle’s lock-
open device.
A portable container made of metal or conductive plastic is
preferred because it dissipates charge to ground more readily.
5) Clean up gasoline spills /splashes immediately.
If possible, move the generator away from spilled gasoline on the
ground.
Wipe up spilled gasoline, and wait 5 minutes for excess gasoline to
evaporate before starting engine.
Gasoline soaked rags are flammable and should be disposed of
properly.
If gasoline is spilled on your skin or clothes, change clothes and
wash skin immediately.
6) Replace gasoline cap securely before starting engine.
7) Store extra gasoline in a cool, dry place in an UL-approved, tightly sealed
container.
IMPORTANT:
For continuous operation, be prepared to check and refuel the engine on
a regular basis. A tank of gasoline should last about 4 hours under
100% load, and about 8 hours under 50% load.
Start LPG/NG
supply
(if using)
Propane (LPG):
1) Make sure the fuel hose is securely connected to the propane tank
regulator on one end, and the ¾” NPT gas inlet on the generator base on
the other end.
2) Open the propane tank main valve.
3) Check ¾” NPT gas inlet connection for leaks each time you connect. Use
the leak test method described below.
Natural Gas:
1) Make sure the gas line is securely connected to the ¾” inlet on the
generator base.
2) Open line valve, if gas line is so equipped.
3) Check ¾” NPT gas inlet connection for leaks each time you connect.
Use the leak test method described below.