Filter
Top Products
Machine Component Identification - Item #165938N
10
Reference 9 – Vibration
Isolation Mounts
The engine and generator are mounted on rubber
cylinders that absorb most of the engine vibration.
This feature eliminates the tendency of the machine to
“walk” which is common in engine powered equipment.
Reference 10 – Oil Drain Plug
Refer to your Honda engine manual for oil change
recommendations.
Reference 11 – Super Silent
Muffler
Noise level is 8 dB less than Honda’s standard muffler.
Reference 12 – Air Cleaner
Refer to your Honda engine manual for air cleaner
care.
Reference 13 – Engine Key
Switch
The engine key is located on the engine. Always
locate this switch and be familiar with its location
before operating the generator. Consult the Honda
engine owner’s manual for further instructions.
Reference 14 – Fuel Valve
The engine has an ON-OFF valve mounted on the
front of the engine. Always keep this valve closed
when the generator is not in use.
Reference 15 – Choke Lever
Used during cold starts. The choke is only used with
gasoline fuel. Refer to Honda engine manual for
usage.
Reference 16 – Recoil
Grasp firmly when starting engine.
Reference 17 – LPG / NG – ¾”
NPT Inlet
Before you start engine, smell next to floor for gas, if
you do smell gas:
• DO NOT start engine.
• DO NOT light a match.
• DO NOT flip on an electrical switch.
• Exit area immediately and call gas supplier or
fire department.
Minimum flow range required: NG - 2.0 CFM,
LPG - 5.7 lb/hr.
Pressure Range: 4-6 ounces, OR 7-11 inches of water
column. NEVER over pressurize.
Reference 18 – Demand
Regulator
Supplies the engine LP or NG fuel only if the engine is
running.
Reference 19 – Generator Head
The electricity producing part of the generator.