Filter
Top Products
9
5. When engine starts, move choke lever to RUN
position.
6. Loads may now be connected to generator.
STOPPING
1. Disconnect all loads to generator.
2. Place key to the OFF position.
3. Turn gas line valve to OFF position.
ENGINE CARE
Refer to your Honda Owner’s Manual for proper care
and maintenance.
NOTE: When changing the oil on a hot engine, the oil
might overshoot the oil drain hole on the generator base.
GENERATOR CARE
The generator head is a 2-pole, 3600-RPM, 60-Hz,
brushless, revolving field and synchronous type with one
sealed ball bearing. The rotor of the generator head is
directly connected to the engine crankshaft and the stator
is rigidly coupled to the engine casting via the generator
head casting.
Exercising the Generator - The generator should
be operated every four weeks. This is accomplished by
starting the engine and applying a load for 10 to 15
minutes. This will dry out any moisture that has
accumulated in the windings. If left, this moisture can
cause corrosion in the winding. Frequent operation of the
engine generator will also ensure that the set is operating
properly should it be needed in an emergency.
Generator Maintenance - The generator head is
brushless and maintenance free. Major generator service,
including installation or replacement of parts should be
performed only by a qualified electrical service technician.
USE ONLY NORTHSTAR APPROVED REPAIR PARTS
AVAILABLE AT 1-800-270-0810.
A. Bearing - The bearing used in these generators is a
heavy duty sealed ball bearing. They require no
maintenance or lubrication.
B. Receptacles - Quality receptacles have been
utilized. If a receptacle should become cracked or
otherwise damaged, replace it. Using cracked or
damaged receptacles can be both dangerous to the
operator and destructive to the equipment.
WARNING, Stand-by Operation
If your generator is to be used as a standby electric
power source in case of utility failure, it must be installed
by a registered and licensed electrician and in compliance
with all applicable state and local electrical codes. Also,
local Fire Departments must be consulted concerning
proper and safe handling procedures for gasoline. NEVER
connect any generator to any existing electrical system
without an isolating, UL approved transfer switch, installed
by a licensed electrician.