Filter
Top Products
7. ADJUSTMENT OF THE SCOPE
ON THE RIFLE
Type and dimensions of the reticle
The type and dimensions are
represented on the drawing. The
brightness of the reticle may be adjusted
by the knob (8). The dimensions are
quoted in meters for the 100 m distance.
For a distance other than 100m the dimensions must be calculated
accordingly in proportion.
Before adjusting of the scope its objective should be set for a
distant object (select infinity) in dark time with the opened cover of
the objective.
The adjustment of the scope should be performed either in daytime
with the closed cover of the objective or in the twilight using an
adjusted target or a remote point.
Adjustment of the scope is performed in the following way:
• Fix the scope on the rifle.
• Set a panel with a target or select the point of aiming.
• Set the rifle on the scope machine.
• Direct the rifle to the point of aiming by mechanical sight (bead
with a slot) (if possible). At this stage it is suitable to apply laser
of cold test shooting (LCTS) inserted in the barrel of the rifle,
which indicates geometrical point of the barrel position (sold
separately).
• Unscrew the protective caps of the reticle adjustment screws.
Turning those screws obtain the matching of reticle crosshairs
with the aimed point, set by the mechanical sight or LCTS;
• Remove the rifle from scoped machine and take out LCTS;
• Make 2-3 shots. Having examined the target make necessary
corrections (for example, in order to move the hit point
downwards and leftwards, screws of the mechanism should be
turned counter clockwise, in the directions Down and Left
correspondingly. The aiming point is moving upwards and
rightwards correspondingly);
14
4. SUPPLIED ACCESSORIES
DN482/483 is supplied in the following assembly:
- Device
- Objective lens cap
- Rubber eyepiece guard
- Weaver rifle mount
- User’s manual
- Warranty card
- Case
Optional accessories
:
-Weaver rail rifle mount (7/8’’)
- Built-in IR illuminator
- Camera/video adapter (52mm/37mm)
-Side mount for East European type rifle.
1 pc.
1 pc.
1 pc.
1 pc.
1 pc.
1 pc.
1 pc.
1 pc.
1 pc.
1 pc./each
1 pc.
5. OPERATION INSTRUCTIONS
WARNING!
NEVER OPERATE YOUR NIGHT VISION DEVICE IN
DAYLIGHT AREAS WITHOUT THE LENS COVER ON!
NEVER AIM THE LENS IN THE DIRECTION OF BRIGHT
LIGHT!
a. Battery installation
DN482/483 requires two AA batteries. Make sure that the batteries
are in good condition and polarity is
installed as it is indicated on the body
of battery compartment (5).
In order to change the batteries
unscrew the cover of battery
compartment (5) and install the new
batteries, observing correct polarity.
NOTE: In order to ensure the longest operation time of the device
and full power of the IR illuminator (using one set of batteries) it is
7