Filter
Top Products
42 1-866-NEUTON1 (638-8661) www.neutonpower.com
ALWAYS REMOVE THE SAFETY KEY AND BATTERY BEFORE PERFORMING ANY ADJUSTMENTS,
MAINTENANCE, OR REPAIRS TO YOUR MOWER.
P
ROBLEM CORRECTIVE ACTION
The Mower runs,
but the cutting
performance is
unsatisfactory, or
there is a loss of
power.
⇒ The Battery was probably not at full charge prior to Mowing. Charge the Battery,
if necessary.
⇒ The Blade may be dull, bent, loose or damaged. Remove the Safety Key and the
Battery, turn the Mower over, and check the condition of the Blade. Sharpen,
tighten, or replace the Blade, if necessary.
⇒ The grass may be too high or too thick for the cutting height. Raise the cutting
height or narrow your cutting swath and try again.
The Mower is hard
to push.
⇒ The grass may be too high or too thick for the cutting height. Raise the cutting
height or narrow your cutting swath and try again.
⇒ The Wheels may not be rotating freely. Remove the Safety Key and the Battery,
turn the Mower over, and check the Wheels for damage.
The Battery loses its
charge quickly.
⇒ The Battery was probably not at full charge prior to Mowing. Charge the Battery,
if necessary.
NOTE: You will need to charge a new Battery at least five (5) times to achieve maximum
cutting time.
⇒ The grass may be too high or too thick for the cutting height. Raise the cutting
height or narrow your cutting swath and try again.
⇒ The Battery may be getting old. After some time, usually about five (5) years, you
will need to replace the Battery.
The Mower rear
Bagger is collecting
grass poorly.
⇒ The rear Bagger is full. Empty the Bagger, and clean it if necessary.
⇒ The grass is too long or the Mower is cutting too low. Raise the cutting height.
⇒ The Mower is moving too fast, slow down.
⇒ The mesh holes in the rear Bagger are clogged, clean them out.
⇒ The rear Bagger is wet. Allow it to dry thoroughly before using it again.