Filter
Top Products
NEUTON CE 6.2 Battery-Powered Mower -
Safety & Operating Instructions
13
Step 5: Attach the Side Discharge Chute, Mulching Plug, or Rear Bagger
Side Discharge Chute
The Side Discharge Chute (Figure 5) allows for proper discharge of the grass, which prevents clogging.
The Chute is shipped without the Handle so you will have to install the Handle prior to use using a
small Phillips Screwdriver. The Handle and Screw are located in the Product Pack bag that shipped
with the Mower.
1. Raise the hinged Discharge Guard on the back of the Mower (Figure 5).
2. Orient the Discharge Chute as shown in Figure 5. Position the two (2) Hangers on the Chute over
the Support Rod (Figure 5) and lower the Chute into place (Figure 5).
3. Lower the hinged Discharge Guard.
Mulching Plug
To mulch your grass, install the Mulching Plug.
1. If necessary, remove the Rear Bagger or Side
Discharge Chute from the Mower.
2. Install the Mulching Plug (Figure 6). Be sure to
push the Plug all the way in until the Notch in its
bottom is engaged.
There’s a slight knack to installing the Plug; push the
Plug in with a slightly arcing motion as follows:
• Align the Plug in the Mower.
• Start to push the top of the Plug in first.
• Then put pressure towards the bottom and slide in
the Plug.
Figure 5
Discharge Guard
Support Rod
Side Discharge Chute
TIP
Figure 6
Engage Notch
Hangers