Filter
Top Products
18
MAINTENANCE
SERVICE RECOMMENDATIONS
PROCEDURE
FIRST
2
HOURS
BEFORE
EACH
USE
OFTEN
EVERY
5
HOURS
EVERY
10
HOURS
EVERY
25
HOURS
BEGINNING
EACH
SEASON
BEFORE
STORAGE
SNOW THROWER
Tighten all Screws and
Nuts
✓ ✓ ✓
Check Traction Clutch
Cable Adjustment (See
Cable Adjustment)
✓ ✓
Check Auger Clutch
Cable Adjustment (See
Cable Adjustment)
✓ ✓ ✓
Adjust Drive Belts
✓ ✓ ✓
Lubricate Chains and Hex
Shaft
✓ ✓
Lubricate Auger Shaft
(See Shear Pin Replace-
ment)
✓ ✓
Lubricate Free-Hand
Linkage
✓ ✓ ✓
ENGINE
Oil, Check
✓ ✓ ✓
Oil, Change
✓ ✓ ✓
NOTE: The warranty on this snow thrower does not cover items
that have been subjected to operator abuse or negligence. To
receive full value from the warranty, operator must maintain
snow thrower as instructed in this manual.
The above Service Recom mendations are supplied to assist the opera-
tor to properly maintain the snow thrower. This is a check list only. Adjust-
ment referred to will be found in the MAINTENANCE section of this
manual.
AFTER EACH USE
1. Check for any loose or damaged parts.
2. Tighten any loose fasteners.
3. Check and maintain the auger.
4. After each use, remove all snow and slush off the snow thrower to
prevent freezing of auger or controls.
5. Check controls to make sure they are functioning properly.
6. If any parts are worn or damaged, replace immediately.