Filter
Top Products
OPERATION
11
F-031306L
HOW TO USE THE CULTIVATOR
How To Stop The Cultivator
1. Release the throttle control to stop the
tines.
2. Move the ON/OFF switch, on the engine,
to the OFF position.
How To Set The Depth
Your model will either have a depth stake or
a depth rod to control the tilling depth and
the forward speed. Set the depth stake or
the depth rod to the desired tilling position
as follows:
1. Remove the hairpin and the clevis pin
from the depth stake or depth rod (see
Figure 7).
2. Adjust the depth stake or depth rod up-
ward to dig shallower or downward to dig
deeper.
3. Reinstall the clevis pin and hairpin.
Figure 7
Clevis Pin
Depth Rod Bracket
Hair Pin
Depth Stake
Bracket
Clevis Pin
Depth Rod
Depth
Stake
HOW TO
OPERATE THE CULTIVATOR
1. Start the engine. See “How To Start The
Engine”.
2. Tilt the unit back on the depth stake or
depth rod until the tines are off the
ground. Squeeze the throttle control all
the way up against the hand grip. The
engine is governor controlled and must
be run at full throttle while tilling.
3. Hold the handle firmly and slowly tilt the
unit forward to begin the tilling action.
4. As the tines begin to make contact with
the ground, hold back on the handles so
that the tines will dig into the soil and not
ride forward over the ground.
5. Avoid tilling soil that is too dry as it will
pulverize and produce a dust that will not
hold water. Also, tilling soil that is too wet
will be hard on the machine and produce
unsatisfactory clods.
6. Lowering the depth stake will slow the
cultivator and make it till deeper. Raising
the depth bar will allow it to move faster
and till more shallow. See “How To Set
The Depth Stake or Depth Rod”.
WARNING: Keep away from the
rotating tines. Rotating tines
can cause injury.