Filter
Top Products
MQ SP2 SLAB SAW — PARTS & OPERATION MANUAL — REV. #7 (09/08/06) — PAGE 27
Stopping the Engine (13 HP Honda Engine)
MQ SP2 SLAB SAW — SHUT-DOWN PROCEDURES
1. Place the
forward/reverse speed
lever
in the NEUTRAL position
(Self propelled models only).
NEVER stop the engine while the blade is in the cut, except for
extreme emergencies. A sudden stoppage of the engine at high
speed while in a cut could damage the blade and/or saw, and
may cause injury to the user or other in the operating area.
2. Place the
engine throttle lever
(Figure 30) in the SLOW
position, and listen for the engine speed to decrease.
Figure 29. Speed Lever
(Neutral Position)
Stopping the Engine (20 HP Honda Engine)
1. Place the
forward/reverse speed lever
in the NEUTRAL
position (Self propelled models only).
2. Place the
engine throttle lever
(Figure 33) in the SLOW
position, and listen for the engine speed to decrease.
Figure 30. Throttle Lever
2. Turn the console
engine ON/OFF switch
(Figure 31) to the
OFF position.
Figure 31. Engine ON/Off Switch (Off Position)
3.
Place the fuel valve lever (Figure 32) to the OFF position.
Figure 32. Fuel Valve Lever (Off Position)
3. Turn the
engine ON/OFF switch
(Figure 34) to the OFF
position.
Figure 33. Throttle Lever (Slow Position)
Figure 34. Ignition Switch (OFF Position)
Emergency Stop Procedure
1. Turn the console
engine ON/OFF switch
(Figure 34) to the
OFF position.
WARNINGWARNING
WARNINGWARNING
WARNING