Filter
Top Products
PAGE 24 — MQ MP2 MASONRY SAW — OPERATION MANUAL — REV. #2 (03/12/13)
Figure 15. Engine Oil Dipstick (Removal)
3. Insert and remove the dipstick without screwing it into
the filler neck. Check the oil level shown on the dipstick.
4. If the oil level is low
(Figure 16), fill to the edge
of the oil filler hole with the
recommended oil type
(Table 5). Maximum oil
capacity is 1.16 quarts (1.1
liters)
Figure 16. Engine Oil Dipstick (Oil Level)
Before Starting
1. Read safety instructions at the
beginning of manual.
2. Clean the saw, removing dirt and
dust, particularly the engine cooling
air inlet, carburetor and air cleaner.
3. Check the air filter for dirt and dust. If air filter is dirty,
replace air filter with a new one as required.
4. Check carburetor for external dirt and dust. Clean with
dry compressed air.
5. Check fastening nuts and bolts for tightness.
Engine Oil Check
1. To check the engine oil level, place the saw on a secure
level surface with the engine stopped.
2. Remove the filler dipstick from the engine oil filler hole
(Figure 15) and wipe clean.
Fuel Check
1. Remove the gasoline cap located on top of fuel tank.
2. Visually inspect to see if the fuel level is low. If fuel is
low, replenish with unleaded fuel.
3. When refueling, be sure to use a strainer for filtration. DO
NOT top-off fuel. Wipe up any spilled fuel
immediately!
DANGER - Explosive Fuel
Motor fuels are highly flammable and
can be dangerous if mishandled. DO
NOT smoke while refueling. DO NOT
attempt to refuel the pump if the engine
is
hot!
or
running
.
EPYTLIO.5ELBAT
nosaeS erutarepmeT epyTliO
remmuS rehgiHroC°52 03-W01EAS
llaF/gnirpS C°01~C°52 02/03-W01EAS
retniW rewoLroC°0 01-W01EAS
MP2 MASONRY SAW — PRE-SETUP (GASOLINE ENGINE)
To disconnect the
mechanical water pump
from the drive
V-belts for
Dry Cutting
, perform the following:
1. Loosen the 2 hex head cap screws (Figure 14) that
secure the pump mount bracket.
2.
Pull
the pump handle
upward
to disengage the pump.
3. Tighten the 2 hex head cap screws that secure the
pump mount bracket.
Figure 14. Pump Disengage
ALWAYS use the
water feed system
unless special
dry cut
blades are being used. If dry cutting is required
disconnect
water pump.
Dry Cutting Setup (Gasoline Only)
CAUTION - Dry Cutting
CAUTION - Explosive Fuel
UPPER
LOWER