Multiquip MP2050E1 Pole Saw User Manual


 
PAGE 20 — MQ MP2 MASONRY SAW — OPERATION MANUAL — REV. #2 (03/12/13)
Whenever cleaning, adjusting or lubricating any part
of the saw, MAKE CERTAIN to place the power ON/
OFF switch in the OFF position and disconnect the
plug from the power source.
MP2 MASONRY SAW — PRE-SETUP (ELECTRIC MOTORS)
Assembly (Electric Powered Saws Only)
1. Remove the MP2
Masonry Saw from its container and
place it on a stable, level surface. Make sure location
you choose can support the weight of the saw. The
saw location should be rigid and stationary so that the
saw will not move, sag, or sway due to the vibrations
and movements of the saw.
2. Connect the barb fitting to the water pump. Attach the
clear plastic water hose (Figure 6) coming from the blade
guard to the water pump.
3. Fill the water tray with
clean fresh water
. The
water
pump intake must always be fully covered by water
.
Also, keep the pump intake free of sludge, debris and
other materials that may accumulate in the tray.
4. Make certain that the water hose will not come in
contact with the blade or interfere with any moving
parts. The best location for the water pump/strainer is
between the splash shield and the rear of the water
tray. This will prevent some of the abrasive particles
from flowing through the pump.
Conveyor Cart Placement
1. Place the conveyor cart across the water tray as shown
in Figure 8. Align the wheels of the cart with the outer
edge of the water tray. Push the cart back and forth, it
should move freely in both directions.
Figure 6. Water Tray/Water Pump
Figure 7. Water Pump Power Connection
Figure 8. Conveyor Cart Placement
Pre-Setup
WARNING - Shut-down Saw for Cleaning
For three-phase motors, you may be required to install
a plug on the end of the water pump power cable, which
should have 3 wires exposed. Have a qualified electrician
install a male plug that has bee properly rated for the
equipment(230V).
Once a plug has been installed, insert the power plug
into the receptacle plug cord attached to the motor.
(Electric Motor Components, item 3)
5. Insert the water pump
power plug
into the outlet
receptacle on the electric motor conduit box as shown
in Figure 7.