Filter
Top Products
MLT25 SERIES LIGHT TOWER • OPERATION MANUAL — REV. #0 (11/28/12) — PAGE 15
COMPONENTS
13. Tongue Jackstand — Use this jackstand to support
the tongue when attaching the light tower to a towing
vehicle.
14. Safety Chain — Always attach safety chain to the
towing vehicle. Never tow the light tower with the safety
chain unattached.
15. Ball Hitch Coupler — Attach this coupler to the
towing vehicle. Use only the specified ball diameter
as indicated on your coupler. Use of any other ball
diameter will create an extremely dangerous condition
which can result in separation of the coupler and ball
or ball failure.
16. Vertical Mast Winch — Use this winch to raise the
mast to the vertical position.
17. Mast Lock/Release Pin — Pull this pin to start placing
the tower mast in the vertical position. When tower
mast has reached full vertical position, insert pin to
keep mast from falling.
18. Tie-Down Points — Used to tie down light tower with
strap or chains to allow even application of force to
the front and rear of the equipment during transport.
19. Fuse Block Assembly — Contains the fuses that
protect the lamp circuit breakers.
20. License Light — This light illuminates the license plate.
Whenever towing of the light tower is required, make
sure this light is operational.
21. Brake Lights — Before towing the light tower, make
sure that these lights are operational and are working
correctly. Never tow the light tower if these lights are
inoperative.
22. Engine Exhaust Pipe — Directs engine exhaust to
the rear of the light tower. NEVER block this exhaust
pipe with obstructions. ALWAYS place the generator
in an area free of obstructions.
23. Tires — This light tower uses ST205/75D15 LR-C size
tire. Replace with only recommended tire size. Never
tow light tower with bad or worn tires.
24. Circuit Breakers, 3-Pole, 15 A — Turn the lamps on
and off.
REAR VIEW FRONT VIEW
20
2121
22
23
24
Figure 3. Major Components (Front/Rear)