Filter
Top Products
PAGE 22 —KD1800/KD6 A.C. GENERATOR— PARTS & OPERATION MANUAL — REV. #1 (06/16/05)
Fan Belt Tension
A slack fan belt may contribute to overheating, or to
insufficient charging of the battery. Inspect and adjust it in
accordance with the
KUBOTA
engine manual.
The fan belt tension is proper if the fan belt (Figure 5) bends
7 to 9 mm (0.28- to 0.35) when depressed with the thumb as
shown in Figure 8 below.
CAUTION :
When adding coolant or anti-freeze to the
radiator, DO NOT remove the radiator cap
until the unit has completely cooled.
Figure 5. Fan Belt Tension
Radiator
Day-to-day addition of coolant or anti-freeze is done via the
reserve tank. See maintenance section (radiator) of this
manual for filling requirements.
Cleaning the Radiator
The radiator may overheat if the fins become overloaded
with dust or debris. Periodically clean the radiator fins with
compressed air.
KD1800/KD6 — PRE-SETUP (ENGINE)