Filter
Top Products
PAGE 16 —GB3LED LIGHTING SYSTEM • OPERATION AND PARTS MANUAL — REV. #0 (03/18/14)
RAISING THE MAST
Before raising the mast, make sure the upper T-handle bolt
lock (Figure 12) is securely tightened. This will prevent the
balloon/lamp assembly from falling off. In addition make
sure that the lamp power cable is connected to the mating
end of the 15 ft (4.5 meters) power source cable.
DANGER
ALWAYS make sure
the area above the
lighting system is open
and clear of overhead
power lines and other
obstructions. The mast
extends in excess of
13 ft. (4 meters) when
an optional extension
is used. Contact with
overhead power lines
or other obstructions
could result in equipment
damage, serious Injury
or death!
CAUTION
When raising mast, ALWAYS be on the lookout for
overhead obstructions such as high voltage power lines.
The possibility exists of electrocution, even death! if
the lighting system comes in contact with high voltage
power lines.
DANGER
When raising mast, ALWAYS
be on the lookout for overhead
obstructions such as high voltage
power lines. The possibility exists
of electrocution, even death! if the
lighting system comes in contact
with high voltage power lines.
SETUP
5. To improve stability and to prevent tipping of the light
unit, place sand bags or similar type weight over the
tripod legs or weight hook as shown in Figure 12.
Figure 12. Sand Bags
6. Raise mast to desired height and tighten lower T-handle
(Figure 12) securely.
SAND
BAGS
MAST
RAISE
LOWER
T-HANDLE
UPPER
T-HANDLE
WEIGHT
HOOK