Filter
Top Products
PAGE 16 — GA-2.5H A.C. GENERATOR — OPERATION & PARTS MANUAL — REV. #5 (03/04/08)
GA-2.5H — CONTROLS AND INDICATORS
This
HONDA
engine is equipped
with a low oil shutdown
capability. A built in sensor will
automatically turn off the engine
should the oil level fall below a
safe operating condition. Make
sure the generator is placed on
level ground. Placing the generator on level ground will ensure
that the low oil sensor will function properly.
NOTE
1. 120V Output Receptacle – This NEMA L5- 20R twist-
lock receptacle will provide 120V, 20 amps, 60 Hz.
Applies to units with S/N 5496763 and above.
2. GFCI Receptacle – This 5-20R duplex receptacle will
provide 120V at all times.
3. AC-Voltmeter – This voltmeter indicates (with a mark)
the rated 60 Hz, single phase output voltage. In addition
the voltmeter can also be used as a diagnostic tool. If the
voltmeter indicator (needle) is below the rated voltage,
engine problems may exist (low/high RPM's). To prevent
damage to the generator or power tools turn the generator
OFF and consult your authorized MQ service dealer.
4. Ciruit Breaker – To protect the generator from an
overload, a 2- pole 20 amp circuit breaker is provided on
the control box. Make sure to place the circuit breaker to
the "OFF" postion prior to starting the engine.
5. GFCI Ground – This ground connection point should
be connect to a good earth ground (ground rod).
Applies
to units with S/N 5496762 and below.
6. ON-OFF Switch – place engine ON/OFF switch in the
"ON" position for normal operation. To turn- off the
generator place switch in the "OFF" position.
7. Chassis Ground – This ground connection point should
be connect to a good earth ground (ground rod).
Applies
to units with S/N 5496763 and above.
Figure 2A. Generator Components