Filter
Top Products
PAGE 46 — DCA-600SSK — OPERATION AND PARTS MANUAL (STD) — REV. #7 (04/30/10)
Figure 52. Voltage Adjust Control Knob
Figure 53. Ammeter (No Load)
13. The ammeter (Figure 53) will indicate zero amps with no
load applied. When a load is applied, the ammeter will
indicate the amount of current that the load is drawing
from the generator.
12. The generator's AC-voltmeter (Figure 51) will display the
generator’s output in VOLTS. If the voltage is not within
the specified tolerance, use the voltage adjustment
control knob (Figure 52) to increase or decrease the
desired voltage.
Figure 51. AC Voltmeter
Figure 47. Pre-Heat Lamp
8. Place the
engine throttle lever
in the “LOW” position
(Figure 48).
Figure 50. Frequency Meter (Hz)
Figure 49. Engine Ignition Switch
9. Turn the ignition key to the “START” position (Figure 49)
and listen for the engine to begin cranking. After the
engine starts release the ignition key.
Figure 48. Engine Throttle Control
10. Once the engine has started, let it run for 3-5 minutes,
then turn the throttle handle control (Figure 48) to the
“HIGH” position.
6. When starting the generator in COLD weather conditions,
turn the
ignition key
to the “PREHEAT
” position (Figure 46),
Figure 46. Ignition Switch (Pre-Heat)
11. The generator's frequency meter (Figure 50) should be
displaying the 60 cycle output frequency in HERTZ.
7. Verify that the pre-heat lamp(Figure 47) is lit (ON) before
starting engine.
5. Set the
battery ON/OFF switch
(Figure 45) to the “ON”
position.
Figure 45. Battery ON/OFF Switch
DCA-600SSK— GENERATOR START-UP PROCEDURE (MANUAL)
Pre-Heat
Lamp