Filter
Top Products
PAGE 36 — DCA-600SSK — OPERATION AND PARTS MANUAL (STD) — REV. #7 (04/30/10)
Generator Output Voltages
A wide range of voltages are available to supply voltage for
many different applications. Voltages are selected by apply-
ing jumpers (6) to the
voltage change-over board
(Figure 15).
To obtain some of the voltages as listed in Table 7 (see
below) will require a fine adjustment using the
voltage regu-
lator
(VR)
control knob
located on the control panel.
Voltage Change-Over Board
The
voltage change-over board
(Figure 15) is located on
the control box, behind the generator control panel. This
board has been provided for ease of voltage selection.
Figure 15. Voltage Change-Over Board
240V Configuration
DCA-600SSK — GENERATOR OUTPUTS
Generator Amperage
Tables 8 and 9 describe the generator’s current output capa-
bility for both 1Ø-phase and 3Ø phase applications.
segatloVelbaliavArotareneG.7elbaT
esahP-eerhT
V802V022V042V614V044V084
esahP-elgniS
V021V721V931V042V452V772
erepmArotareneG.8elbaT
Ø1—sgnitaR
WkV931V042V772V084
0488276144138
08675333982761
021368005334052
061151,1766875333
002934,1338227714
042727,1000,1668005
082410,2761,1110,138
5
023203,2333,1551,1766
063095,2005,1003,1057
004878,2766,1444,1338
044561,3338,1885,1719
)xam(084354,3000,2337,1000,1
erepmArotareneG.9elbaT
Ø3—sgnitaR
WkV042V084
0402106
08142021
021163081
061184142
002106103
042227163
082248124
023269184
063380,1145
004302,1106
044323,1266
)xam(084344,122
7
NEVER attempt to place jumper plates on the voltage
change-over board while the generator is in operation. There
exists the possibility of electrocution, electrical shock or
burn, which can cause severe bodily harm or even death!
DANGER - CHANGING JUMPER PLATES