Filter
Top Products
PAGE 44 — DCA-500SSK — PARTS AND OPERATION MANUAL (STD) — REV. #1 (04/14/01)
General Inspection Prior to Operation
The DCA-500SSK generator has been thoroughly
inspected and accepted prior to shipment from the factory.
However, be sure to check for damaged parts or
components, or loose nuts and bolts, which could have
occurred in transit.
Extension Cable
When electric power is to be provided to various tools
or loads at some distance from the generator,
extension cords are normally used. Cables should be
sized to allow for distance in length and amperage so
that the voltage drop between the generator and point
of use (load) is held to a minimum. Use the Cable
Selection Guide (Table 8) for selecting proper cable
size.
Circuit Breakers
To protect the generator from an overload,
a 3-pole,1400
amp,
main main
main main
main
circuit breaker is provided to protect the
UVW output terminals from overload. In addition two
single-pole, 20 amp
GFCIGFCI
GFCIGFCI
GFCI
circuit breakers are provided
to protect the GFCI receptacles from overload. Three 50
amp
loadload
loadload
load
circuit breakers have also been provided to
protect the load side of the generator from overload. Make
sure to switch
ALLALL
ALLALL
ALL
circuit breakers to the "OFF" position
prior to starting the engine.
DCA-500SSK — PRE-SETUP
)noitarepOesahPelgniS,zH06(noitceleSelbaC.01elbaT
tnerruC
ni
serepmA
sttaWnIdaoLhtgneLelbaCelbawollAmumixaM
021tA
stloV
tA
042
stloV
eriW01#eriW21#eriW41#eriW61#
5.2003006.tf0001.tf006.tf573.tf052
50060021.tf005.tf003.tf002.tf521
5.70090081.tf053.tf002.tf521.tf001
0100210042.tf052.tf051.tf001
5100810063.tf051.tf001.tf56
0200420084.tf521.tf57.tf05
.egatlovwolmorftlusernacegamadtnempiuqE:NOITUAC
ALWAYS consult with a licensed
electrician for correct extension
cord wire size.
NOTE