Filter
Top Products
PAGE 36 — DCA-25SSIU2 (50 HZ)— OPERATION AND PARTS MANUAL — REV. #0 (03/11/05)
NORMAL SHUT-DOWN
To shutdown the generator, use the following procedure:
1. Switch the MAIN, AUX and GFCI circuit breakers
(Figure 53) to the “OFF” position (no load).
Figure 53. Main, AUX. and GFCI
Circuit Breakers (OFF)
EMERGENCY SHUT-DOWN SHUTDOWN
1. To shut-down the engine in the event of an emergency,
switch the
MAIN
,
GFCI
and
LOAD
(Figure 55) circuit
breakers to “OFF” position.
2. Turn the ignition switch key to the “STOP” position.
2. Let the engine cool by running it for 3-5 minutes with no
load applied (circuit breakers in the off position).
3. Place the ignition switch (Figure 54) in the “STOP” position,
remove the key and store in a safe place.
Figure 54. Ignition Switch (Stop Position)
4. Remove
all
loads from the generator.
Figure 55. Ignition Switch (Off Position)
DCA-25SSIU2 (50 HZ)— GENERATOR START-UP PROCEDURE/
SHUTDOWN
16. Turn the
main
,
GFCI
, and
aux
. circuit breakers to the
“ON” position (Figure 51).
17. Observe the generator's ammeter (Figure 52) and verify
it reads the anticipated amount of current with respect
to the load. The ammeter will only display a current
reading if the load is in use.
18. The generator will run until manually stopped or an
abnormal condition occurs.
Figure 52. Ammeter (Load)
Figure 51. Main, AUX. and GFCI
Circuit Breakers (ON)