PAGE 26 — DCA-15SPX3 GENERATOR— PARTS & OPERATION MANUAL — REV. #2 (09/03/01)
DCA-15SPX3 — OUTPUT TERMINAL INFORMATION
DCA-15SPX3 FAMILIARIZATION
The Output Terminal panel is provided with the following:
z
One GFCI 120 Volt Receptacle, 20 Amp (single-phase)
z
15 kW Output Terminal (UNV)
z
Ground Terminal
z
Main Circuit Breaker 65 amps
z
GFCI Circuit Breaker 20 amps
120 Volt Receptacle
One GFCI Duplex Nema 5-20R (120V, 20 Amp) receptacle
is provided on the output terminal. This receptacle can be
used anytime the generator is in operation. The receptacle
is controlled by the circuit breaker located on the control
panel.
Pressing the reset button resets the receptacle after being
tripped. Pressing the "Test Button" (See Figure 7) in the
center of this receptacle will check the GFCI function. The
receptacle should be tested at least once a month.
Figure 7. GFCI Test Button
NEMA L5-30R Output Receptacle
The L5-30R receptacle supplies 30 amps at 120 volts. A 30
amp circuit breaker helps protect any load that it is feeding.
NEMA L6-30R Output Receptacle
The L6-30R supplies 30 amps at 240 volts. A 30 amp circuit
breaker helps protect any load that it is feeding.
NEMA CS-6369 Output Receptacle
The CS-6369 supplies 50 amps at 120/240 volts. A 50 amp
circuit breaker helps protect any load that it is feeding.
Connecting Load
Loads can be connected to the generator by the UNV Lugs or
the duplex receptacle (See figure 3). Make sure to read the
operation manual before attempting to connect a load to the
generator.
Circuit Breakers
The DCA-15SPX3 has a main 65 amp circuit breaker and
receptacle circuit breakers that are listed above. The main
purpose of the circuit breakers is to protect the load the generator
is powering.
Maximum Output
The entire load connected to the UNV Lugs and both slots in
the duplex receptacle must not exceed 16.5 kW in standby or
15 kW in prime output.
Maximum Amps
The generator will provide a maximum total amps of 62.5.
Do not exceed the maximum allowed amperage!