Filter
Top Products
PAGE 30 — DCA-10SPX3 A.C. GENERATOR— PARTS & OPERATION MANUAL — REV. #2 (01/17/11)
General Inspection Prior to Operation
The DCA-10SPX3 generator has been thoroughly inspected
and accepted prior to shipment from the factory. However,
be sure to check for damaged parts or components, or loose
nuts and bolts, which could have occurred in transit.
Extension Cable
When electric power is to provided to loads (ie. power
tools) at a distance from the generator, extension cables
are used. Cables should be sized to allow for distance in
length and amperage so that the voltage drop between
the generator and point of use (load) is held to a minimum.
Use Table 6 (cable selection guide) as a guide for selecting
proper cable size.
Circuit Breaker
To protect the generator from an overload,
a 3-pole, 50 amp,
main
circuit breaker is provided to protect the UNV output
from overload. In addition a 2-pole, 20 amp
GFCI
circuit
breaker is provided to protect the GFCI receptacle from
overload. Make sure to switch both circuit breakers to the
"OFF" position prior to starting the engine.
DCA-10SPX3 — PRE-SETUP
)noitarepOesahPelgniS,zH06(noitceleSelbaC.6elbaT
nitnerruC
serepmA
sttaWnIdaoLhtgneLelbaCelbawollAmumixaM
021tA
stloV
042tA
stloV
eriW01#eriW21#eriW41#eriW61#
5.20
03006.tf0001.tf006.tf573.tf052
50060021.tf005.tf003.tf002.tf521
5.70090081.tf053.tf002.tf521.tf001
0100210042.tf052.tf051.tf00
1
5100810063.tf051.tf001.tf56
0200420084.tf521.tf57.tf05
.egatlovwolmorftlusernacegamadtnempiuqE:NOITUAC
ALWAYS consult with a licensed
electrician for correct extension
cord wire size.
NOTE