Filter
Top Products
5
SECTION 2: CONTENTS OF HARDWARE PACK
Lay out the hardware according to the illustration for identification purposes. Part numbers are shown in
parentheses. (Hardware pack may contain extra items which are not used on your unit.)
NOTE: The augers are secured to the spiral shaft with two shear bolts and hex lock nuts. If you hit a hard foreign
object or an ice jam, the snow thrower is designed so that the bolts may shear. Two replacement shear bolts and
nuts are provided for your convenience. Store in a safe place until needed.
A
ATTACHING THE HANDLES
B
ATTACHING THE CHUTE ASSEMBLY
ATTACHING THE CHUTE DIRECTIONAL
C
D
ATTACHING THE SHIFT ROD
AND CLUTCH CABLES
F
AUGER SHEAR BOLTS (SPARES)
Shear Bolts
(710-0890A)
ATTACHING THE TRACK CONTROLS
Track Control Triggers
CONTROL ASSEMBLY
Eyebolt Not Shown
Hex Bolts
(710-3180)
5/16-18 x 1-3/4”
Hex Bolts
(710-3008)
5/16-18 x 3/4” Handle Tabs
(784-5599)
Lock Washers
(736-0119)
5/16” I.D.
Carriage Bolts
(710-0262)
5/16-18 x 1-1/2”
Cupped Washers
(736-0242)
5/16” I.D.
5/16” Thread
Hex Nuts
(712-3010)
Hex Bolts
(710-3015)
1/4-20 x 3/4”
Chute Flange
(731-0851A)
Keepers
Hex Lock Nuts
1/4-20 Thread
(712-3027)
Ferrule
(711-0677)
Hair Pin Clip
(714-0104)
3/8” I.D. x 5/8” O.D.
Flat Washers
(736-0275)
Flat Washers
(736-0185)
3/8” I.D. x 5/8” O.D.
Hair Pin Clip
(714-0104)
Cupped Washers
(736-0242)
5/16” I.D.
Hex Nut
(712-3010)
5/16” Thread
(747-0697)
(746-0950)
(712-0429)
Hex Lock Nuts
5/16” Thread
E