Filter
Top Products
RULES FOR SAFE OPERATION
GB5
ASSEMBLY INSTRUCTIONS
ATTACHING AND REMOVING THE BLOWER/
VACUUM TUBE
Attaching
NOTE: The blower/vacuum tube comes unassembled
on this unit. Installation is required to provide
safe and easy use for the operator.
1. Remove the screws and nuts provided from the
hardware pack.
2. Insert the blower/vacuum tube all the way into the
opening on the motor housing until the holes in the
tabs on the blower/vacuum tube align with the screw
holes in the housing (Fig. 1).
APPLICATION
As a blower
• Cleaning of yards, garages, driveways, porches,
patios, around walls, fences, etc.
As a vacuum
• Picking up leaves, light debris, etc.
Harness
Blower/Vacuum Tube
Vacuum Bag
Blower/Vacuum Mode
Change-Over Lever
Blower/Vacuum Inlet
Blower Outlet
Vacuum Bag Hook
Vacuum Bag Zipper
Petrol Cap
Throttle
Lever
Primer
Choke Lever
Air filter/muffler cover
Spark Plug
Starter Rope
Grip
Ignition Switch
KNOW YOUR UNIT
3. Insert the 2 (two) 8-32 x 3/4” slotted T20 Torx screws
into the right side of the motor housing and the 2 (two)
nuts into the left side of the motor housing (Fig. 2).
4. Tighten the screws firmly. Do not over-tighten.
5. Install the 2 (two) remaining self-tapping 8-16 x 3/4”
slotted T20 Torx screws into the holes on either side
of the housing (Fig. 2). Tighten until snug, do not
over-tighten.