Filter
Top Products
7
3
Assembling
Your Tiller
WARNING
Do not put your
fingers under the
belt cover.
Maximum tire
pressure under any
circumstances is
30 p.s.i. Equal tire
pressure should be
maintained on both
tires.
Figure 3-3
Figure 3-4
Figure 3-5
Attaching Control Rod
• Make sure the handle assembly is in the highest
position. Refer to Know Your Tiller section.
• Remove hairpin clips from control rod, (rubber
washers to remain on control rod).
• Insert the shorter, (angled), end of the control rod
through the indicator bracket on the shift cover and
secure with hairpin clip that was previously removed.
See Figure 3-5.
• Insert the longer end of the control rod through the
hole in the gear selector handle and secure with
hairpin clip.
Final Clutch Adjustment
IMPORTANT: Service the engine with oil and gasoline
before checking this adjustment. Refer to the separate
engine manual packed with your tiller for proper fuel and
engine oil recommendations.
Position the tiller so the front counterweight is against
a solid object, such as a wall. With the gear selection
lever in NEUTRAL, start the engine. Refer to the
separate engine manual.
Standing on the right side of the tiller, examine the belt
(inside the belt cover). It should not be turning.
WARNING: Do not put your fingers under
the belt cover.
If the belt turns without bail engaged, adjust by
unthreading the internally threaded tube at the end
of the cable a few turns clockwise (when standing in
operator’s position) and then retighten the nut against
the tube.
Now move the shift lever to FORWARD position.
Carefully engage the clutch by lifting the clutch control
bail against the handle. The wheels should spin.
If the wheels do not spin with the unit in forward, adjust
by unthreading the tube at the end of the cable a few
turns counter-clockwise (when standing in operator’s
position) and then retighten the nut against the tube.
Recheck both adjustments, and readjust as necessary.
NOTE: A secondary cable adjustment is available if you
reach the point that additional adjustment is needed.
Remove the belt cover and move the hex nuts at the
other end of the cable towards the end of the casing.
Then readjust the hex nuts at the handle.
Tire Pressure
The tires on your unit may be over-inflated for shipping
purposes. Reduce the tire pressure before operating
the unit. Recommended operating tire pressure is
approximately 20 p.s.i. (check sidewall of tire for tire
manufacturer’s recommended pressure).
WARNING: Maximum tire pressure under
any circumstances is 30 p.s.i. Equal tire
pressure should be maintained on both
tires.
Internally
Threaded Tube
Slot Head Screw, Nut,
& Flat Washers
Plastic Fitting
Slot Head Screw
Flat Washers
Nut
Internally
Threaded Tube
Threaded
Eyebolt
Clutch Control
Nut
Rubber Washer
Control Rod
Indicator Bracket
Hairpin Clip
Idler Pulley Rod
NOTE: Specifications are
subject to change without
notification or obligation.
Images my not reflect your
exact model and are for
reference purposes only.