Filter
Top Products
9
For accessories and additional info contact your local dealer/distributor.
Dealer contact info can be found at: www.mosquitomagnet.com/dealers
Shut Down
Starting Instructions
It is recommended that you read the entire manual before
starting the Liberty Plus trap.
1 . Connect regulator to propane tank.
2 . Slowly open propane tank valve.
3 . Push ON/OFF switch to ON position.
LED light will turn solid orange indicating warm-up.
After 15 to 25 min. trap LED light will turn solid green
indicating the trap is running at full capacity.
Shut Down Instructions
Push ON/OFF switch to OFF position to shut down the Liberty
Plus. The LED light will go out and the fan will continue
running until trap is cool. Close the propane tank valve and
disconnect regulator.
Any open Mosquito Magnet
®
attractant should be removed
and discarded. See attractant label for disposal instructions.
The net should also be discarded prior to storing the
Liberty Plus.
S T O R A G E : Liberty Plus should be stored indoors in the
off-season. Cover unit with trap cover available at your local
dealer or with a tarp and secure tightly at the bottom to keep
out dust, spider webs and other debris.
N O T E : It is recommended that you use the Quick Clear valve
before seasonal storage to avoid build-up of contaminants
during off-season (see page 10).
Maintenance
• 21 Day Maintenance Cycle
- Refill propane. (propane lasts approximately 21 days with
24-hour operation) on a 20lb tank. Trap uses approximately
1lb of propane per day.
- Replace short-range attractant cartridge.
See Mosquito Magnet
®
attractant label for instructions.
- Empty or replace net.
• Utilize the Quick Clear valve at first tank change and every
second tank change thereafter.
• Periodically wipe down the outside of the Liberty Plus
with a clean, water damp cloth.
• Charge your Mosquito Magnet
®
Liberty Plus for 24 hours
at the beginning of each season (see page 7).
Maintenance
8
American Biophysics
ON/OFF Switch
Propane Tank Installation
1 . After trap is placed in its ideal location, place propane
tank onto the molded cradle.
2 . Making sure propane tank is fully closed. Attach propane
regulator hose to propane tank. Secure tightly by hand.
Do not use tools.
3 . Turn propane on s l o w l y. Take care not to turn too quickly
to avoid engagement of safety check valve regulator.
DO NOT MOVE TRAP WITH TANK AT TACHED!
TANK MUST BE DISCONNECTED FROM REGULAT O R
BEFORE TRAP IS RELOCATED TO AVOID DAMAGE TO
R E G U L ATOR AND/OR TRAP. BE ADVISED, DAMAGE
CAUSED FROM FAILURE TO COMPLY WITH THIS
INSTRUCTION IS NOT COVERED UNDER WA R R A N T Y.
Propane Tank Changing Tips
When attaching the regulator handle to a tank after a tank
change, be sure to fully tighten the regulator handle onto the
tank. No need to use tools, but do turn the handle as far as
possible by hand. When this is done, loosen the handle 1/4 turn,
then re-tighten the handle. Frequently this action will result in
additional turns beyond the 1/4 turn.
The purpose for this is to fully engage the regulator onto the
tank. If the regulator is not fully engaged, the flow of gas may
be restricted to the point where the trap will show a gas empty
code. If this occurs, press the off button, close the tank valve,
and remove the regulator from the tank. Re-attach the regulator
and try again.
Installation
Step 1 – Propane Tank Placement
Step 2 – Attach Regulator
Step 3 – S l o w l y Open Va l v e
For Best Results
• Your trap will begin capturing immediately, but allow
4 – 6 weeks to significantly reduce the mosquito population
in your yard.
• Never spray insecticide in or around trap.
• Trap can be left running in the rain.
• If using lime or fertilizer compounds, be sure
to shut down the Liberty Plus first to prevent dust or fine
mist from being drawn into trap and clogging net.