Filter
Top Products
It is recommended that you read the entire manual before starting the Mosquito Magnet Defender
ASSEMBLY/STARTING INSTRUCTIONS
TRAP PLACEMENT
1
2
3
4
Determine the direction of the prevailing wind.
Stand in the center of the area you are trying to protect and look toward the prevailing wind. Proper
placement of the Mosquito Magnet will be 30-40 feet in front of you, within 5-6 feet of ground cover
(i.e., bushes, flowerbeds, treeline, marshbed, etc.)
It is recommended that the trap be placed in the shade.
Do not place trap directly above water source (sprinklers, hose, etc.).
Make sure unit is not directly up against a blockade such as a building or fence.
Trap must be placed on level ground to avoid tipping or uneven propane distribution.
For more information, refer to trap placement section of our website at www.mosquitomagnet.com.
5
6
7
9
Plug power connector into
the Defender unit power
slot located on the back of
the power head.
Plug adaptor into properly
grounded electrical outlet.
This adaptor is not intended
to be mounted. For UL Listed
trap use 120 Vac adaptor.
For CE marked trap use 230
Vac adaptor.
Turn propane on by slowly
turning counterclockwise.
Take care
not
to turn too
quickly to avoid engage-
ment of safety check valve
in regulator.
11
10
CONTINUE
TO STARTING
INSTRUCTIONS.
9
10
STARTING INSTRUCTIONS
1
2
3
4
5
6
7
Connect regulator to propane tank.
Plug power connector into the trap.
Plug AC adapter into electrical socket. To avoid the risk of electrical shock, connect only to properly
grounded outlets. Adaptor unit is not intended to be mounted.
Slowly
turn propane tank on (turn valve counter clockwise).
Turn rocker switch to “on” position.
The red light on the switch will flash for up to 20 minutes (warm up phase).
Once the light stops flashing and is solid the Mosquito Magnet is fully operational.