Filter
Top Products
f. “M.SC H/L Button”; To change between high and low power, press and release the
H/L button.
To scan only the 5 channels in memory locations 1 through 5, press the “F” function
button and release, then press and release the “M.SC” button. To stop memory scan,
press the up, down, or PTT button.
HOW TO OPERATE YOUR TRANSCEIVER FOR CB
1. Insert the antenna in the antenna connector.
2. Insert 6 alkaline or nic-cad batteries into the battery compartment, noting polarity.
3. Rotate the ON/OFF volume control clockwise to turn the unit on. Adjust the volume
for a normal listening level.
4. Adjust the SQUELCH control.
5. Select the desired channel by the up or down buttons.
An optional mobile adapter is available that will transform your 75-820 into a mini
mobile.
Check with your Midland dealer or the Midland factory.
Note: If the channel will not change, check that the “LOCK” button has not been
pressed. In this case, press the the “LOCK” button to deactivate this function.
To transmit: press and hold the PTT button, then talk into the microphone.
To receive: simply release the PTT button.
TO RECEIVE WEATHER
Press the WX, button then select one of the channels in your area from the 10 channels
available.
CAUTION: DON’T EXPOSE THE DISPLAY TO EXTREME HOT OR COLD
TEMPERATURES
CARE OF RECHARGEABLE NI-CAD BATTERIES
Always follow the battery manufacturers recommendations for charging
and disposing of ni-cad batteries.
The following is meant as general information regarding ni-cad batteries.
1. Occasionally allow the batteries to fully discharge before recharging. Full discharge
will be indicated by the low battery indicator coming on during receive operation.
2. Always allow the battery to fully charge before using.
3. The above will prevent the batteries from developing “memory” which effectively
reduces their capacity.
4. It is better to store ni-cad batteries that are discharged rather than charged.