Meyer 2636 Spreader User Manual


 
Model V-Max —18—
FIGURE 9. PRIMARY CHAIN DRIVE
RH TOP
SPROCKET
ROLLER CHAIN
IDLER
NYLON
ROLLER
PTO INPUT
SPRING LOADED ADJUSTER
The primary chain drive (PTO input shaft to the large
RH top sprocket, figure 9) is automatically tensioned
by a spring loaded idler nylon roller. The extension
spring should extend 2"
from its neutral 5" total length.
Manual adjustment for the automatic tensioning idler,
nylon roller assembly is located at the left rear
of the
spreader’s front bearing mounting plate.
SPRING LOADED ADJUSTER
The transfer chain drive (large RH top sprocket to the
large LH top sprocket, figure 10) is automatically
tensioned by a spring loaded idler nylon roller. The ex
-
tension spring should extend 2
“ from its neutral 5" total
length.
Manual adjustment for the automatic tensioning idler,
nylon roller assembly is located at the front center
of
the spreader’s front bearing mounting plate.
WARNING: DISCONNECT PTO DRIVE SHAFT AND HYDRAULIC HOSES (RELIEVE HYDRAULIC
PRESSURE) BEFORE CLEANING, ADJUSTING, LUBRICATING OR SERVICING THIS SPREADER. FAILURE
TO HEED MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH.
FRONT DRIVE ROLLER CHAINS
There are five roller chain drives located at the front of the spreader. Regularly check that all tensioning springs
are in serviceable condition for automatic roller chain tightening. Manually adjust spring tensioners (as needed) by
turning double locknuts on all tensioning bolt/idler assemblies. Proper roller chain tension is when 1/4" to ½" de
-
flection occurs on the slack side of the chain. Regularly re-check all roller chain tensions. Keep all roller chains
tight at all times! For clarity purposes, the following illustrations detail each roller chain reduction separately.
NOTE:
The side bars of the roller chains will wear into the idler nylon rollers up to the rollers of the roller chain
forming grooves. These grooves will serve as a guide when the roller chain loosens due to normal use. From this
point on, after tightening, the idler nylon rollers should run for hundreds of hours without any noticeable wear.
FIGURE 10. TRANSFER CHAIN DRIVE
IDLER NYLON
ROLLER
ROLLER
CHAIN
LH TOP
SPROCKET