Stand Assembly Instructions
7
To assemble the Stand supplied with the Trap, follow the instructions shown in figure 2 below.
NOTE: For optimum performance place the trap in a predominantly shaded area (located between
your dwelling and the source of the mosquitoes) which is protected from rain and wind. (Mosquitoes
do not fly in strong winds or severe weather conditions.)
For maximum stability the 'U' shaped leg at the back of the stand should be pointed in the direction
of prevailing winds. The wire staples supplied with the trap (or a cinder block placed on the back of
the stand) can be used to increase stability.
Fit top section over bottom section of upright - then fit bolt
and tighten firmly
Assemble stand base components as illustrated here - fit all bolts and
washers before tightening bolts firmly. Screw feet into bottom of stand base.
3 x 4" Wire staples are supplied to secure frame to ground.
Wind
direction
FIG 2 - Trap Assembly Instructions
Fix external skirt then tip the Trap on its side and slide onto hook.
U.S. Design Patent No 449,091