McCulloch 5258669-01 Chainsaw User Manual


 
K. EC DECLARATION OF CONFORMITY
ENGLISH - 9
Husqvarna UK Ltd., Aycliffe Industrial Park
Newton Aycliffe, Co. Durham, DL5 6UP, England
Declare under our sole responsibility that the product(s);
Category.....................................Electric Chainsaw
Type(s) ......................................ES716, ES718, ES720, ES722
Identification of Series............... See Product Rating Label
Year of Construction.................. See Product Rating Label
Conforms to the essential requirements & provisions of the following EC Directives:
98/37/EC (until 31.12.09), 2006/42/EC (from 01.01.10), 2004/108/EC, 2000/14/EC
based on the following EU harmonized standards applied:
EN60745-1, EN60745-2-13, EN50366, EN55014-1, EN61000-3-2, EN61000-3-11
Notified Body that carried out the EC type-examination
in accordance with article 8 section 2c....................... TÜV Rheinland Product Safety
GmbH, 0197
Am Grauen Stein
D-51105 Köln, Germany
Certificate no. ............................................................. 15023261 001
The maximum A weighted sound pressure level LpA at the workstation, measured according to EN ISO
11203, recorded on a sample of the above product(s) corresponds to the Level given in the table.
The maximum hand / arm vibration weighted value measured according to EN ISO 5349 on a sample of the
above product(s) corresponds to the Value a
h
given in the table.
2000/14/EC: The Measured Sound Power L
WA
& Guaranteed Sound Power L
WA
values are according to the
tabulated figures.
Conformity Assessment Procedure.............Annex V
Notified Body............................................... Intertek, Cleeve Road
Leatherhead, Surrey
KT22 7SB, England
Newton Aycliffe 19/03/2009
M.Bowden
Research & Development Director
Husqvarna UK Ltd.
EN 61000-3-11 Compliance statement
Depending on the characteristics of the local electricity supply network, use of this product may result in
short voltage drops at the instant of switching on. This may influence other electrical equipment e.g a
momentary dimming of a lamp. If the Mains impedance Z
max of your electricity supply is less than the value
shown in the table (applicable to your model) then these effects will not occur. The value of the network
impedance may be determined by contacting your electricity supply authority
Type ES 716 ES 718 ES 720 ES 722
Dry Weight (Kg) 4.2 4.3 4.4 4.4
Power (kW) 1.6 1.8 2.0 2.2
Oil tank volume (cm
3
) 115 115 115 115
Chain pitch (inches) 3/8 3/8 3/8 3/8
Chain gauge (mm) 1.3 1.3 1.3 1.3
Measured Sound Power L
WA
(dB(A)) 104 106 106 106
Guaranteed Sound Power L
WA
(dB(A)) 106 106 107 109
Sound pressure Level (dB(A)) 91 91 90 91
Value a
h
(m/s
2
) 4.63 4.63 3.76 4.65
Uncertainty K of a
h
(m/s
2
) 1.5 1.5 1.5 1.5
Mains-Impedance Z
max (Ohm) 0.345 0.345 0.296 0.332