Filter
Top Products
8
Service maintenance guide
Area Maintenance procedure Frequency
Spline male/female connection of the
inner drive shaft
Lubricate 20-25 hrs
Gear case
Use a grease gun to insert lubricant
into the grease nipple of the gear case.
Use EP2 lithium grease
20-25 hrs
Guide bar
Inspect/clean/replace
The guide bar opening should be always
a square. When it’s worn, the chain tilts.
Check for wear of the guide bar opening.
Worn bar needs to be repaired or replaced.
Keep lubrication opening of the
guide bar clean from sawdust
Before each use
Remove
Lubricate
Grease nipple
Remove sawdust
from the groove
Guide bar lubrication opening
GOOD
WORN
GUIDE BAR SECTION