Filter
Top Products
8
Tools:
9
/
16
" wrench, pin or screwdriver
1. Lock the gear shaft by inserting the pin or screwdriver
through the aligned keyholes in the gear case cover and the
gear case to prevent rotation (Picture 19).
2. Hold the pin or screwdriver in place and remove bolt by
turning it clockwise (Picture 20), then remove clamping
plate (Picture 21), and worn blade (Picture 22).
3. Place new blade (Picture 23), re-install clamping plate
(Picture 24), and bolt (Picture 25). Use wrench to tighten
the blade-mounting bolt. If bolt is worn or damaged use a
new one. Replace worn or damaged blade and bolts in
sets to preserve balance.
Replacement Blade Installation
Picture 19
Picture 20
Picture 23
Picture 24
Picture 25
Picture 21
Picture 22
WARNING – DANGER
BE SURE UNIT IS UNPLUGGED BEFORE
MAKING ANY ADJUSTMENTS.