Filter
Top Products
7
Check the balance of the assembled unit. The handles and
shoulder harness have been assembled at the factory and set
according to the average sized person. This can be adjusted to
the operator’s preference.
1. Unit handles can be re-adjusted to the operator’s
preference by simply loosening the screws and sliding
handles up or down the shaft. Re-tighten the screws
(Picture 16). The distance between the replacement portion
of the blade and the foremost portion of the guiding handle
should be at least 18" (450mm). (Picture 17)
2. Wheel height can be re-adjusted by loosening clamp lever,
and changing the height of the wheel to achieve desired
cutting depth. (Picture 18) Up-deep cut, down-shallow cut.
Balancing and Depth Adjustment
No tools are required to attach the Edge Trimmer to the power
head assembly.
1. Pull the spring pin up on the adapter of the power head
shaft assembly. (Picture 14)
2. Carefully fit edger drive shaft into adapter, making sure
that male spline of the inner drive shaft engages into the
female spline socket of the power head shaft.
3. When the drive shaft is properly aligned, the spring pin
will drop into the hole on the shaft of the edger attachment.
A click should be heard when completed.
4. Insure two shaft parts are fully engaged by twisting them.
5. Full engagement will prevent shaft rotation.
6. Secure assembly by tightening the knob. (Picture 15)
Attaching the Edger to the
Power Head assembly.
Picture 14
Picture 15
Picture 16
Picture 17
Picture 18
down
up