Filter
Top Products
6
Tools:
9
/
16
" wrench, pin supplied with the unit or
screwdriver
1. Remove the following parts from the Edge Trimmer
Assembly: blade mounting bolt #1 by rotating it
clockwise, clamping plate #2, gear case cover #3,
holding screws #4, and cover #5. (Pictures 1 and 2)
2. Install the blade guard to the gear case aligning 3
mounting holes (Picture 4), then put on cover #5,
align all holes and install 3 screws. (Picture 5)
3. Attach the blade guard to the tube using Clamping
bracket and two screws. (Picture 6)
4. Install gear case cover (Picture 7), blade (Picture 8),
clamping plate (Picture 9), and install blade
mounting bolt with washers. Left thread, rotate
counter-clockwise to tighten. (Picture 10)
5. Lock the gear shaft by putting a pin provided or
screwdriver through the aligned keyholes in the gear
case cover and the gear case. Use a socket wrench to
tighten the blade-mounting bolt. Rotate bolt counter
clockwise to tighten. (Picture 11)
6. Split the bracket, install the wheel assembly to the
tube, and clamp it at the position best for your job,
using two screws. (Picture 12 and 13)
7. You can replace loop handle with the U-shaped
handle that comes with your Edge Trimmer
Attachment.
Assembling the Edge Trimmer
Picture 1
Picture 2
Picture 3
Picture 4
Picture 5
Picture 6
Picture 7
Picture 8
Picture 9
Picture 11
Picture 10
Picture 12
Picture 13
1
2
5
3
4
3
2
1
4
5
Gear Case
Blade Guard
Shaft
Clamp
Gear
Case
Cover
Blade
Clamping Plate
Mounting
Bolt
Pin
Bracket
Screws
Cover
4.0-4.5”