Filter
Top Products
8
ENGLISH
Parts supplied
Explanation of general view
SPECIFICATIONS
1) The data assign equal weight to the full-load and maximum speed operating conditions.
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Note: Specifications may differ from country to country.
Symbols
END218-1
The following show the symbols used for the tool. Be sure
that you understand their meaning before use.
.................. Read instruction manual and follow the
warnings and safety instructions.
....................DOUBLE INSULATION
...................Caution: particular care and attention
required!
...................Caution: withdraw the mains plug
immediately if the cable is damaged!
1. Rear handle
2. Switch trigger
3. Oil filter cap
4. Front handle
5. Front hand guard
6. Guide bar
7. Saw chain
8. Lever
9. Sprocket cover
10. Oil level sight
11. Rear hand guard
12. Serrated rail (claw stop)
13. Lock-off button
14. Chain catcher
15. Scabbard
1. Lock-off button
2. Switch trigger
3. Press in
4. Loosen
5. Sprocket cover
6. Adjusting dial
7. Adjusting pin
8. Hook
9. Hole
10. Small hole
11. Tighten
12. Lever
13. Low
14. High
15. Guide bar
16. Saw chain
17. Oil filler cap
18. Hand guard
19. Lock
20. Unlock
21. Sight glass
22. Serrated rail
23. Felling area
24. Oil guide groove
25. Oil feed hole
26. Push nut
27. Slotted bit screwdriver
28. Filter
29. Sprocket
Model UC3020A UC3520A UC4020A
Max. chain speed (m/s) 13.3
Cutting length 300 mm 350 mm 400 mm
Saw chain
Type 90SG
Pitch 3/8”
Acoustic power level L WA av dB (A)
to EN 50144 -1
1)
105.3
Sound pressure level L pA av dB (A)
at the workplace to EN 50144 -1
1)
92.3
Vibration acceleration a h,w av to
ISO 50144-2-13
1)
- Front handle m/s
2
3.4 3.9
- Rear handle m/s
2
4.0 4.5
Oil pump Automatic
Oil tank capacity (l) 0.20
Power transmission Direct
Chain brake Manual
Run-down brake Mechanical
Overall length (without guide bar) 436 mm
Net weight 3.8 kg
Extension cable (optional) DIN 57282/HO 7RN -F L=30 m max., 3 x 1.5 mm
2