Filter
Top Products
For
RBC260
and
RBC310
The handle comes in three parts; two handles and
one handle holder assembly. (One half of handle
holder is already fitted to pipe case, the other half
of handle holder is in plastic bag with four socket
head bolts). Place the two handles in the half of
handle holder fitted to pipe case (the flared ends
fit into grooves in handle holder). Place the loose
handle holder over handles and other handle holder
on the pipe case and fix together with the four
socket head bolts, Ensure the throttle assembly
is
on correct side and before final tightening, adjust
rake of handle to suit.
Route the throttle wire and ignition wires through
locations on handle towards engine.
3.
Assembly
of
throttle wire and ignition wire
Remove plastic cover from carburetor.
Insert throttle wire through adjusting screw and
fit nipple of throttle wire into swivel of carburetor.
Adjust the adjusting screw to take
up
free play of
wire ensuring the throttle is fully opened when
throttle lever is in high speed position and
2 ~
3
mm
(0.079"
~
0.118")
free play when in low
speed position. Re-fit plastic cover.
Connect the female and male bullet connectors
from throttle assembly to the male and female
bullet connectors coming from engine.
6
,