Filter
Top Products
11
To meet the applicable safety provisions, only the tool/
protector combinations as indicated in the table must be used.
(1)
(2)
(3)
MOUNTING OF PROTECTOR
For EM2650UH
In use of the metal blade, x the protector (3) to the clamp (2) with two bolts –
M6 x 30 (1).
NOTE: Tighten the right and left bolts evenly so that the gap between the clamp
(2) and the protector (3) will be constant.
Otherwise, the protector sometimes may not function as specied.
(3)
(4)
(1)
(2)
(4)
(3)
In cases where the nylon cord cutter is to be used, be sure to mount the –
protector extension (4) onto the metal blade protector (3).
Mount the protector extension (4) by sliding it into place from the ank of the –
metal blade protector (3) as shown.
Remove tape adhered to cutter, which cuts nylon cord, on protector extension –
(4).
CAUTION: Be sure to push in protector extension (4) until it is fully inserted.
Take care not to injure yourself on the cutter for cutting the nylon
cord.
To remove the protector extension (4), apply a hex wrench into the notch on –
the metal blade protector (3), push it in and meanwhile slide the protector
extension (4).
For EM2650LH
Install the clamp (3) on the shaft so that the projection of the clamp (3) is –
inserted into the opening between the gear case (1) and the shaft.
Secure the protector (4) with the installation bolts M6 x 30 (2).
Hex wrench