Filter
Top Products
4
Start the Brushcutter or String Trimmer only in accordance with the instructions.
Do not use any other methods for starting the engine! –
Use the Brushcutter/String Trimmer and the tools only for such applications –
as specified.
Only start the engine, after the entire assembly is done. Operation of the –
device is only permitted after all the appropriate accessories are attached!
Before starting make sure that the cutting tool has no contact with hard –
objects such as branches, stones etc. as the cutting tool will revolve when
starting.
The engine is to be switched off immediately in case of any engine problems. –
Should the cutting tool hit stones or other hard objects, immediately switch off –
the engine and inspect the cutting tool.
Inspect the cutting tool at short regular intervals for damage (detection of –
hairline cracks by means of tapping-noise test).
Operate the equipment only with the shoulder strap attached which is to –
be suitably adjusted before putting the Brushcutter or String Trimmer into
operation. It is essential to adjust the shoulder strap according to the user
size to prevent fatigue occurring during use. Never hold the cutter with one
hand during use.
During operation always hold the Brushcutter or String Trimmer with both –
hands.
Always ensure a safe footing.
Operate the equipment in such a manner as to avoid inhalation of the exhaust –
gases. Never run the engine in enclosed rooms (risk of gas poisoning).
Carbon monoxide is an odorless gas.
Switch off the engine when resting and when leaving the equipment –
unattended, and place it in a safe location to prevent danger to others or
damage to the machine.
Never put the hot Brushcutter or String Trimmer onto dry grass or onto any –
combustible materials.
The cutting tool has to be equipped with it appropriate guard. –
Never run the cutter without this guard!
All protective installations and guards supplied with the machine must be –
used during operation.
Never operate the engine with faulty exhaust muffler. –
Shut off the engine during transport. –
During transport over long distances the tool protection included with the –
equipment must always be used.
Ensure safe position of the equipment during car transportation to avoid fuel –
leakage.
When transporting, ensure that the fuel tank is completely empty. –
When unloading the equipment from the truck, never drop the Engine to the –
ground or this may severely damage the fuel tank.
Except in case of emergency, never drop or cast the equipment to the ground –
or this may severely damage the equipment.
Remember to lift the entire equipment from the ground when moving the –
equipment. Dragging the fuel tank is highly dangerous and will cause damage
and leakage of fuel, possibly causing fire.
Refueling
Shut off the engine during refueling, keep away from open flames and do not –
smoke.
Avoid skin contact with mineral oil products. Do not inhale fuel vapor. Always –
wear protective gloves during refueling. Change and clean protective clothing
at regular intervals.
Take care not to spill either fuel or oil in order to prevent soil contamination –
(environmental protection). Clean the brushcutter or string trimmer
immediately after fuel has been spilt.
Avoid any fuel contact with your clothing. Change your clothing instantly if –
fuel has been spilt on it (to prevent clothing catching fire).
Inspect the fuel cap at regular intervals making sure that it can be securely –
fastened and does not leak.
Carefully tighten the fuel tank cap. Change location to start the engine (at –
least 3 meters away from the place of refueling).
Never refuel in closed rooms. Fuel vapors accumulate at ground lever (risk of –
explosions).
Only transport and store fuel in approved containers. Make sure the fuel –
stored is not accessible to children.
Resting•
Transport•
Refueling•
Maintenance•
Tool replacement•
3 meters